How to flood coat a table with epoxy

A seal coat, a measured and slowly mixed batch, no more than the maximum thickness per coat, and a quick pass with heat for bubbles. Step by step, with the maker's numbers.

Before you start

A flood coat is a self-leveling layer of coating epoxy poured over a whole surface, usually 1/8 to 1/4 in (3–6 mm) thick. Use a tabletop or bar-top epoxy, not a deep-pour casting resin. The numbers below are from TotalBoat TableTop's instructions; check your own product's data sheet, since ratios, thickness limits and times differ.

  • Room and material at 65–80 °F (18–27 °C), relative humidity under 60%.
  • The surface level, clean, dry and sanded. Tape the underside of the edges if you want drips to fall clean.
  • Enough epoxy measured out. TotalBoat gives 6.4 sq ft per gallon at 1/4 in, and about 24 sq ft for a seal coat. The flood coat calculator adds edges, seal coat and extra coats for your size.

1. Seal coat (wood, concrete, other porous surfaces)

Spread a thin coat (about 1/16 in) over the whole surface, working it into cracks, knots and voids. It traps the air in the wood so it can't bubble up through the flood coat. Let it cure hard, sand with 80–120 grit, and wipe with denatured alcohol. Non-porous surfaces can skip this.

2. Mix

Measure by the basis the data sheet gives (TableTop is 1:1 by volume, 1.2:1 by weight). Stir slowly for the full time, scraping sides and bottom, without whipping in air. The mix ratio calculator splits a batch into Part A and Part B.

3. Pour and spread

Pour right away in an S-pattern and spread evenly with a spreader. Let it level on its own, and smooth the edges with a gloved finger. No more than 1/4 in per coat: thicker coats trap bubbles and can overheat.

4. Remove bubbles

Wait about 10 minutes, then pass a heat gun or torch 6–8 in above the surface, always moving. Repeat as needed during the first 30 minutes. More in bubbles in epoxy.

5. Second coat and cure

TotalBoat's guide says to pour the next coat within 3–6 hours for a chemical bond, and to sand lightly with 120 grit if more than 8 hours have passed (see layers not bonding). At 70 °F TableTop is tack-free in about 6 hours, sandable in 24, ready for light use in 48 hours and fully cured in 5–7 days. Colder rooms take longer: see cure time and temperature.

Calculate epoxy for a 6 × 3 ft table

Flood coat questions

How thick should an epoxy flood coat be?

For tabletop epoxy, typically 1/8 to 1/4 in per coat. TotalBoat TableTop's maximum is 1/4 in per coat; check your product's data sheet.

Do I need a seal coat before a flood coat?

On wood and other porous surfaces, yes. TotalBoat says to always seal first, or air from the grain rises into the flood coat as bubbles.

How much epoxy do I need to flood coat a table?

TotalBoat gives 6.4 sq ft per gallon at 1/4 in. Edges, the seal coat and waste add more; the flood coat calculator works it out for your size.

When can I pour the second flood coat?

For TableTop, within 3–6 hours for a chemical bond, or after a light 120-grit sanding if more than 8 hours have passed.

Sources