Cloudy, milky or yellow epoxy

Clear epoxy goes cloudy for a few reasons and yellow for a few others. When it showed up tells you which.

Cloudy before you pour: cold resin

Resin stored cold can crystallize and turn cloudy or grainy in the jug. It's a physical change, not spoilage. Warm the jug gently until it's clear again, let it come back to room temperature and mix as normal. Pouring crystallized resin can leave cloudy spots and soft areas.

Cloudy during the cure: moisture

  • Wet wood. Moisture coming out of the wood clouds the epoxy around it. TotalBoat recommends drying wood below 10–12% moisture content before it goes into epoxy.
  • Humidity. Many products cap it: TotalBoat TableTop 0–60%, Fathom 0–80%, Alumilite Amazing Clear Cast under 60%.
  • Amine blush. A cloudy, waxy film on the surface in cool, damp conditions. Wash it off with clean water and an abrasive pad (WEST SYSTEM). Stay at least 5 °F above the dew point (Sherwin-Williams).

Hazy all through: micro-bubbles

Fine bubbles from fast mixing or outgassing wood read as haze. Mix slowly with the stick against the bottom of the cup (Epoxyworks), seal-coat wood first, and let slow deep-pour epoxy rest after mixing. TotalBoat's Fathom data sheet suggests 20–30 minutes in the pail so bubbles can rise. More on this in the first pour checklist.

Yellow right after the pour: overheating

A deep pour that turns yellow, often with cracks, got too hot. TotalBoat says a mass of Fathom poured thicker than advised can reach 200–300 °F or more, causing shrinkage, cracks or yellowing. MAS says Deep Pour X poured over 3 in risks yellowing and cracking. Stay under the product's limit per layer; the deep pour planner splits the pour for you.

Yellow over months: UV

Sunlight yellows epoxy over time. UV-resistant formulas slow it down; a UV-protective topcoat on the finished piece slows it further. Keep river tables out of direct sun where you can.

Can you fix it?

  • Surface blush or haze: wash, sand and recoat, or sand and polish.
  • Cloudiness or yellowing through the casting: it won't clear. For a river or casting, that means cutting it out and repouring, or living with it.

Plan a 4 in Deep Pour X river

Cloudy epoxy questions

Why did my epoxy turn cloudy?

Usually moisture: wet wood, high humidity or amine blush. Cold, crystallized resin and fine bubbles also cause haze. Dry the wood, keep humidity inside the data sheet's range and warm crystallized resin until it's clear before mixing.

Why did my deep pour turn yellow?

It overheated from being poured thicker than the product allows per layer, or in a warm shop. TotalBoat says Fathom poured too thick can reach 200–300 °F and crack or yellow. Split deep pours into layers within the limit.

Can cloudy epoxy be fixed?

Surface haze or blush can be washed, sanded and recoated or polished. Cloudiness through the whole casting is permanent.

Sources