Epoxy layers not bonding
A second pour that peels off, a visible line between layers or a cloudy band in a river all come back to the same three things: timing, surface prep and blush.
The recoat window
While a layer is still partly cured, the next layer bonds to it chemically. Once it's fully hard, the new layer only holds on mechanically, so the surface has to be sanded. Pour too early and the heat of both layers adds up. Every product has its own window:
| Product | Next layer |
|---|---|
| TotalBoat Fathom | Safest after at least 36 h; 24 h is OK once the center is below 85 °F and firm |
| TotalBoat TableTop | At least 3 h between 1/4 in layers |
| EcoPoxy FlowCast | While the previous layer is still tacky; if not, wait about 72 h and sand |
| MAS Deep Pour X | Typically 24–48 h, once cooled to 70–80 °F; scuff-sand with 180 grit |
| System Three MirrorCast | 10–14 h depending on width; no sanding needed within 72 h |
| Stone Coat Ultra Deep | At gel stage (firm but tacky), 17–22 h |
| East Coast Resin Table Top | 4–10 h between flood coats |
| Smooth-On EpoxAcast 692 | Only after the previous layer has fully cured (72 h) |
Missed the window? Sand it
- Wash first if there's any waxy film (amine blush). Sanding blush just smears it around. WEST SYSTEM says to wash with clean water and an abrasive pad.
- Sand the whole surface to a uniform dull scratch. MAS gives 180 grit for Deep Pour X; Stone Coat and Upstart give 220 grit.
- Remove the dust and pour.
Dust or blush trapped between layers shows as a line in clear epoxy, so clean thoroughly before you pour.
Lines from heat and cure differences
Layers of very different thickness cure at different speeds and temperatures. The deep pour planner splits a pour into the fewest equal layers under the product's depth limit and gives the earliest and latest time for each next pour.
Layer questions
Do I need to sand between epoxy coats?
Not if you pour inside the product's recoat window. Outside it, yes. System Three MirrorCast needs no sanding within 72 h; EcoPoxy FlowCast needs sanding once the layer is no longer tacky.
Why did my second epoxy layer peel off?
The first layer was fully cured and not sanded, or it had amine blush, dust or oil on it. Wash, sand to a uniform scratch and clean before the next pour.
Can I pour the next layer too soon?
Yes. Both layers then cure together and the heat adds up, as if you'd poured one thick layer. TotalBoat says to wait until a Fathom layer's center is below 85 °F and firm before the next pour.
Sources
- EpoxyPlan epoxy comparison, from TotalBoat Fathom TDS, TotalBoat TableTop TDS, EcoPoxy FlowCast TDS, MAS Deep Pour X instructions, System Three MirrorCast bulletin, Stone Coat Ultra Deep, Upstart Deep Pour, East Coast Resin directions, Smooth-On EpoxAcast 690/692 bulletin
- WEST SYSTEM: surface preparation