Epoxy fisheyes and pulling away from the edge
A fisheye is a round crater where the epoxy pulls back from a spot and leaves it bare or thin. Pull-back at the edges is the same problem along a line. Both mean the epoxy can't wet the surface there.
Why it happens
Liquid epoxy spreads only over a surface it can wet. Anything with low surface energy repels it, the way water beads on a waxed car. Common culprits:
- Silicone: sprays, lubricants, some caulks, mold release, and anything wiped on with a rag that touched them.
- Wax and furniture polish, including old finishes on reclaimed wood.
- Oil: fingerprints, hand lotion, compressor oil in an air line, natural oils in oily woods.
- Amine blush on a previous coat.
- Dust, which also gives tiny craters.
Bubbles that rise out of the wood and pop leave craters too. That's outgassing, and it's a different fix: a seal coat and matching wood and epoxy temperatures (Epoxyworks).
Edges pulling back
A flood coat has a natural thickness it levels to. Spread it thinner and surface tension pulls it back from edges and high spots. East Coast Resin says its Table Top self-levels at about 1/8 in, with no more than 3/16 in per flood coat. Pour enough for a full coat, let it run over the edges, and brush the drips back up the sides.
The flood coat calculator includes the seal coat and the edges, so you don't run short and spread it thin.
Prep that prevents it
- Keep silicone products out of the shop on finishing days.
- Wash any cured epoxy with water and an abrasive pad to remove blush (WEST SYSTEM), then sand.
- Sand to fresh wood or a uniform scratch on old epoxy, then vacuum.
- Wipe with a clean solvent and fresh paper towels, changing towels often so you don't spread contamination around. Let it flash off fully.
- Wear gloves from the final wipe on.
Fixing a coat that fisheyed
Pouring more epoxy over a fisheye usually opens the same crater again, because the contamination is still there. Let the coat cure until sandable, sand the craters flat, clean as above and recoat.
Fisheye questions
What causes fisheyes in epoxy?
Contamination the epoxy can't wet: silicone, wax, oil, fingerprints or amine blush. The epoxy pulls away from the spot and leaves a crater.
Why does my epoxy pull away from the edges of the table?
The coat is too thin for the epoxy to stay put, or the edges are contaminated. Flood coats level to a set thickness; East Coast Resin gives about 1/8 in for its Table Top. Mix enough for a full coat including the edges.
Can I just pour another coat over fisheyes?
Not without prep. Sand the cured coat, clean the surface and then recoat, or the craters tend to come back in the same places.
Sources
- East Coast Resin: directions for use (flood coat thickness), via the EpoxyPlan epoxy comparison
- WEST SYSTEM: surface preparation
- Epoxyworks: how to coat over wood (outgassing)