Epoxy mix ratio calculator
Turn a total amount into exact Part A and Part B measurements. Volume and weight ratios are different numbers, so EpoxyPlan uses each product's own published ratio for each.
Volume vs. weight
Resin and hardener usually have different densities, so a ratio by volume is not the same as a ratio by weight. TotalBoat puts it plainly: "Do not use the mix ratio by volume for this method of measuring [by weight] because the densities of the two components are usually not the same."
For example, TotalBoat Fathom is 2:1 by volume but 100:44 by weight. EcoPoxy FlowCast and FlowCast SPR are both 2:1 by volume, yet 2.3:1 and 2.5:1 by weight. Smooth-On EpoxAcast 690 and 692 should only be measured by weight.
Never adjust the ratio
West System: "DO NOT attempt to adjust the epoxy cure time by altering the mix ratio… Most problems related to the curing of the epoxy can be traced to the wrong ratio of resin and hardener."
How the split is calculated
By volume, Part A is the total × A ÷ (A + B). By weight, the total weight is the volume × the mixed density, then split the same way using the weight ratio. Example: 1 gal of Fathom at 2:1 by volume is 85.3 fl oz A + 42.7 fl oz B. At 100:44 by weight and 1.1 g/mL, that's about 2,892 g A + 1,272 g B.
Mix ratio questions
Is 2:1 by volume the same as 2:1 by weight?
No. Resin and hardener usually have different densities, so the weight ratio is different. TotalBoat Fathom is 2:1 by volume but 100:44 by weight. Use the ratio the maker publishes for the way you measure.
How do I measure 2:1 epoxy?
Part A is two thirds of the total and Part B is one third. For 1 quart (32 fl oz), that's 21.3 fl oz of Part A and 10.7 fl oz of Part B. For 1 gallon, 85.3 fl oz of A and 42.7 fl oz of B.
Should I measure by volume or by weight?
Either works if you use the ratio the maker gives for that method. Some products, such as Smooth-On EpoxAcast 690 and 692, should only be measured by weight.
Can I add more hardener to make epoxy cure faster?
No. West System warns against changing the mix ratio to adjust cure time, and says most curing problems come from the wrong ratio. To change cure speed, use a different hardener or product.